I'm wondering how others are finishing the alum panel under doors and between front and rear seats? Because it's so tight and you have to insert it about 1/2 inch then slide back to line up holes, it messes up any paint, don't know how others get it in with leather? I must be missing something.
Van's Air Force
Don't miss anything! Register now for full access to the definitive RV support community.
Finishing interior side panel
- Thread starter rvdave
- Start date
Auburntsts
Well Known Member
I painted mine after I installed them (rattle can) but before I installed any of the interior
Hi Dave,
I painted mine prior to assembly. I assembled the interior panels to move my project and recently removed them to continue my interior finishing/wiring. I lifted up as much as possible on the panel that it slides under, and while it did mar the paint a slight bit, it was not enough to run through to the primer. Plus, when assembled, the part that is marred, obviously, is hidden.
I painted mine prior to assembly. I assembled the interior panels to move my project and recently removed them to continue my interior finishing/wiring. I lifted up as much as possible on the panel that it slides under, and while it did mar the paint a slight bit, it was not enough to run through to the primer. Plus, when assembled, the part that is marred, obviously, is hidden.
