danielweberdlc
I'm New Here
I'm trying to learn how to build by building the RV training kit and I ran into an odd problem I can't explain. I'm building the first piece, where you drill 12 #40 holes, dimple and then rivet two pieces of sheet together.
I'm using the Cleaveland tools dimple die sets and C frame.
After I dimpled the holes I was surprised to see my 3/32" cleco's would not stay in the holes, which had somehow enlarged. I'm at a loss to understand what I did wrong. I'm positive I used the correct dies and drill, as the pieces were cleco'd together before I dimpled.
Is it possible to over-dimple to the point where the holes get too big? I'm so confused.
Thanks,
I'm using the Cleaveland tools dimple die sets and C frame.
After I dimpled the holes I was surprised to see my 3/32" cleco's would not stay in the holes, which had somehow enlarged. I'm at a loss to understand what I did wrong. I'm positive I used the correct dies and drill, as the pieces were cleco'd together before I dimpled.
Is it possible to over-dimple to the point where the holes get too big? I'm so confused.
Thanks,