alpinelakespilot2000
Well Known Member
How did you deal with this gap here, shown between the scrap angle and the skin?
I've procrastinated the windscreen fairing as long as possible and need to know what to do with the gap, shown here between the scrap piece of angle and the side of the top skin near the roll bar. Obviously, I'd like the fiberglass to lay flat there between the plexi and the bottom of that top skin where it overlaps the longeron. Question for others who have gone before me on this, should I:
1. Put some filler over the skin here and lay the fiberglass over it?
2. Lay up a layer or two of fiberglass, then fill, then lay more fiberglass on top?
3. None of the above?
Thanks for your suggestions.
I've procrastinated the windscreen fairing as long as possible and need to know what to do with the gap, shown here between the scrap piece of angle and the side of the top skin near the roll bar. Obviously, I'd like the fiberglass to lay flat there between the plexi and the bottom of that top skin where it overlaps the longeron. Question for others who have gone before me on this, should I:
1. Put some filler over the skin here and lay the fiberglass over it?
2. Lay up a layer or two of fiberglass, then fill, then lay more fiberglass on top?
3. None of the above?
Thanks for your suggestions.
Last edited: