After 150 hours, i noticed that the floor of the FAB is getting a wear spot or two from the air filter rubbing on it. I tried searching for some solutions but no joy.
Has anyone seen this and come up with some good ideas?
I could do a fiberglass patch to reinforce it, but it seems like the problem would just reoccur. Seems like a better solution is to create a stronger floor with Al.
Updated 7/17 with photos.
Thanks,
Jae
Has anyone seen this and come up with some good ideas?
I could do a fiberglass patch to reinforce it, but it seems like the problem would just reoccur. Seems like a better solution is to create a stronger floor with Al.
Updated 7/17 with photos.
Thanks,
Jae
Last edited: