mattsrv7
Well Known Member
I'm working though the mid-section of my -7 tip-up fuselage and I'm wondering if it would be okay to use AN426 (flush) rivets in the last three holes connecting the F-757 (doubler plate with the slot to pass through the canopy latch on top of F-705) to the upper longeron to instead of the AN470s? AN426 are called it for the first two holes but AN470 for the last three.
The slider uses the AN426s in that spot for all 5 rivets and countersinks the longerons, so I assume it should be fine. Had anyone done this or checked with Vans on this one?
The slider uses the AN426s in that spot for all 5 rivets and countersinks the longerons, so I assume it should be fine. Had anyone done this or checked with Vans on this one?