ERushing
Well Known Member
Good Afternoon,
Had a couple questions this afternoon:
1) Has anyone tried installing the Ductworks kit in the 2nd to outermost bay instead of the outermost bay? After spending 12 hours over the weekend dimpling and filling the two stall warning holes on the leading edge, I noticed that one of my QB wings came from the factory with a small dent/ blem on the leading edge in the middle of the 2nd to outermost bay.
I thought this might be a good reason to put the landing lights there. Has anyone else tried this before?
2) I'm going to start fabricating the brake lines shortly. Anyone know of a source for 5052 in Portland, OR?
Incidentally - I spent 12 hours on those 4 tiny holes because I FORGOT to do them prior to installing the tanks. I realized the mistake when I was reviewing the plans for completion. So I spent the weekend, removing torque tubes, removing the tanks, dimpling and filling 2 holes and then re-assembling everything!! The good news is that the wings are done with the exception of the fiberglass! Tail mates with the Fuse this coming weekend!
Had a couple questions this afternoon:
1) Has anyone tried installing the Ductworks kit in the 2nd to outermost bay instead of the outermost bay? After spending 12 hours over the weekend dimpling and filling the two stall warning holes on the leading edge, I noticed that one of my QB wings came from the factory with a small dent/ blem on the leading edge in the middle of the 2nd to outermost bay.
I thought this might be a good reason to put the landing lights there. Has anyone else tried this before?
2) I'm going to start fabricating the brake lines shortly. Anyone know of a source for 5052 in Portland, OR?
Incidentally - I spent 12 hours on those 4 tiny holes because I FORGOT to do them prior to installing the tanks. I realized the mistake when I was reviewing the plans for completion. So I spent the weekend, removing torque tubes, removing the tanks, dimpling and filling 2 holes and then re-assembling everything!! The good news is that the wings are done with the exception of the fiberglass! Tail mates with the Fuse this coming weekend!