I'm working on the rudder and got stuck on Pg7-05 Step 2 with riveting the nut plates to the reinforcement plates. The nut plates called out are K1000-6 and are to be riveted with AN470AD4-X rivets. My question is about the size of the holes in the nut plates. The mounting holes appear to be sized for a 3/32" rivet. As the drawing calls out 1/8" rivets, does one just drill out the holes in the nut plates for the larger rivet? If so, I'm assuming that this would apply throughout the build when this type of "conflict" occurs.
Thanks for indulging one of the newbies on the block...
Thanks for indulging one of the newbies on the block...