Dynon D10 EMS - Fuel Configuration

Hey guys,

I'm about to buy a EMS D10 and have a hard time finding information about the configuration of the display.

I'd like to use RPM, MAP, OilP and OilT, CHT and EGT, and Fuel quantity. Unfortunately I only have 1 center fuel tank and like to adapt the display therefore. Is this possible in den D10? The manual is not helpful in this aspect. I only found out that the 4 rightmost positions can be adapted by the user. Hopefully the same goes for the fuel gage.

Maybe some Dynon-Uses can chime in.

Thank you!

Simon

Have you looked at the new JPI EDM-350? It's for Experimentals only, and may be an even smaller package than the D10. Just wondering, as the D10 is a great product, as well.