Rear rudder pedals/Flyboys Accessories

I installed the rear seat rudder pedals into my RV-4. It took less than 20 minutes from start to finish. My test "dummy" in the back was an A-10 Demo Pilot, he loved them! With the A-10 driver flying, there was very little interference between his feet and my hips. So two thumbs up for them. ����

do you have footwells? IF so, where did you put the pedals relative to the wells? I have those pedals and I have to do the same task. Any pics would be very helpful. Thanks

Scott,
I don't have footwells. I mounted the the pedals as close to the rear of the main spar as I could, but still allowing full deflection. My install looked like the picture on Flyboy Accessories website, minus the footwells.

Michael,

Thanks for the kind words. I'm very pleased that you like the product.

Here is a link if anyone wants to see the product photos and description.

Interestingly, we have ONE set that is anodized RED. Normally, they are all clear anodized. If you'd like a RED set, please put a note in the comments section for Blake to see when you order.

Thanks!