Trio Pro Pilot install help

I have a flying RV 7. i will be installing a TRIO PRO PILOT next week. any photos of this type of install will be greatly appreciated. any articles also will be helpfull. i tried the archives, not much there i could find.
fred
thanks for the pics so far but looking for ones that were taken way after the plane was flown and then ap installed. some people tell me they changed locations because of much easier places

Trio install

Roll servo is a bolt-in with supplied parts, however when I did mine it threw the rigging out?? Be sure to check rigging on the servo side with the w-730 template! Pitch needs a little fab work, Keep everything like a three sided parallelogram and watch out for interference between the servo pushrod and Pitch pushrod. Good luck and enjoy the great A/P. Sorry no picks I won't be near the plane for a week.

Trio Install

I found everything I needed included in the installation instructions from Trio. See http://www.trioavionics.com/Pro Pilot Manual 3.7.pdf for the Pro Pilot install instructions. They are well written with color photos.

VETE76 said:

I have a flying RV 7. i will be installing a TRIO PRO PILOT next week. any photos of this type of install will be greatly appreciated. any articles also will be helpfull. i tried the archives, not much there i could find.
fred

Click to expand...

Below are links to photos in my build log. The wing bracket from trio is a direct bolt on to the bell crank. The pitch bracket in the tail is a little less straight forward, but they also provide the parts for it.

http://www.mykitlog.com/users/displ...&project=2102&category=7714&log=155272&row=15

http://www.mykitlog.com/users/displ...&project=2102&category=8097&log=163625&row=15