I just got my RV back today after a GTR200 and GTX335 install. This replaced an Icom A200, a PS Enginnering PMA4000 and a GTX327. Please don’t mention the GTR200B that literally came out as I was getting installed or I’ll start throwing **** (again).
Anyway, I have the strangest problem where the mic is always hot on the pilot side. The radio isn’t being keyed, it’s just the intercom. I’ve put the ICS squelch on auto, 10% and 90% and I can’t seem to change the behavior.
Obviously I’m going to take it back to the shop but in the meanwhile, any advice other than buy a 200B is greatly appreciated.
I just thought of something but I’m going to post anyway. I think my Zulu 3 has a gain adjustment on the mic under the foam. I wonder if it’s too high?
Anyway, I have the strangest problem where the mic is always hot on the pilot side. The radio isn’t being keyed, it’s just the intercom. I’ve put the ICS squelch on auto, 10% and 90% and I can’t seem to change the behavior.
Obviously I’m going to take it back to the shop but in the meanwhile, any advice other than buy a 200B is greatly appreciated.
I just thought of something but I’m going to post anyway. I think my Zulu 3 has a gain adjustment on the mic under the foam. I wonder if it’s too high?
Last edited: