Dynon Skyview Fuel Calibration

Below is a graph of the different readings of the resistive
Vans senders while calibrating the fuel tanks for the new Skyview system.



I was expecting more of a curve from these readings versus almost straight lines. It looks like on the right tank, that the readings might be off a little on the 8 and 11 gallon readings. Wonder if the sender is sticking a little?

Would be a nice feature on the skyview if we could go into the calibration settings and manually adjust/enter them again.

Adjusting settings

Thomas

After you calibrate the fuel senders, you can manually go in and adjust the values. Go back to the fuel calibration screen and have a look. I would be careful about changing these values though.

Thanks Marc,

I will do that. Was hard to sell my legendary Dynons, but sure liking this new Skyview system.