Originally Posted by Jskyking
Getting ready to begin my spars and CH 13 mentions priming the countersink holes.
I was planning on applying using a small amount of primer and a q tip. At this time, I donít want to purchase a gallon of primer and prefer to use a rattle can.
Is there a brand that works? Eventually, I plan on using SWP60G2.
For those tiny jobs I use NAPA 7220. SEM is also good. Spray into a cup and use a q-tip.
Estes Park, CO
wirejock at yahoo dot com
Donated 12/27/2018. Plus a little extra.
RV-7A #73391, N511RV reserved (2,000+ hours)
HS SB, empennage, tanks, wings, fuse, working finishing kit
I cannot be, nor will I be, held responsible if you try to do the same things I do and it does not work and/or causes you loss, injury, or even death in the process.