Ottertrack
Member
I have searched and cannot find this question so will start a new thread. I have the bends in the canopy slider frame very close except for a problem arose. The instructions in Section 9 page 10 state that "The vertical distance from the canopy frame side bows to the F-721B canopy deck should vary by no more than 1/8 inch from front to back". With everything in place, mine is off by 1/4 inch; the front measurement being 2.5 inches and the rear is 2.25 inches. The only way I can see to remedy this is to bend the side bows just rear of the weld where they meet the canopy frame front bow. I'm concerned I could break it at the weld. Is this a good idea? Thanks everyone.