First day of many and already need an opinion. I was test fitting the horizontal stab rear spar reinforcements and noticed that the 2 pieces that butt up together to form the spar don't exactly line up. They are about .035" askew. When I lay them end to end without the reinforcement, they are exactly the same size, but as soon as I cleco the supports in there, the parts shift. Is this normal variability in production? It looks to me as though the holes that are punched in the spar halves are in fact just slightly off from eachother.
Wings in progress
Last edited by Girraf : 09-02-2018 at 12:38 PM.
Reason: Removed Links