thompsonbr87
Well Known Member
I recently replaced my fuel pump which has left me with probably a 10mm hole in the belly skin where the old Weldon pump had an overboard drain. I planned on figuring out what to do about it later, but after a couple of short test flights, I noticed I was getting a slight headache. Well, duh, it's directly aft of the exhaust! I didn't actually have any specific indications of dangerous CO levels (yes, I'll admit to still using the CO cards, but I do at least change them as recommended), but that was one of my first thoughts after connecting the two.
Anyways, I want to be sure this is sealed well and then never think about it again. What's the best way to go about this? Dollop of RTV? Plug? Skin patch?
Anyways, I want to be sure this is sealed well and then never think about it again. What's the best way to go about this? Dollop of RTV? Plug? Skin patch?