Mountain Time
Active Member
After 14 years with the original panel, my 6 is down for installation of a G3X Touch/GTN650 system from SteinAir. One initial task is figuring out where to install the GTP 59 OAT probe. My current sensor is installed through the R fuselage side, under the wing fairing forward of the main spar, but it has always tended to read higher than actual in that location.
What are people recommending for the GTP 59? My sense is that maybe moving it outboard, to a location inside the access panel for the aileron bellcrank would be a good option. But I'd really appreciate input on "known good" locations from those who have been there before me ;-
I'm a frequent reader on VAF but rarely post here - I have a feeling that's going to be changing as I get further into this project!
What are people recommending for the GTP 59? My sense is that maybe moving it outboard, to a location inside the access panel for the aileron bellcrank would be a good option. But I'd really appreciate input on "known good" locations from those who have been there before me ;-
I'm a frequent reader on VAF but rarely post here - I have a feeling that's going to be changing as I get further into this project!