Ok, I’m not sure why I feel like I’m struggling with the Front Spar on my Empennage, but here it is.
I countersunk HS-710 and HS-714. I think I may have gone a little too deep in an attempt to make the dimples on HS-702 fit into the countersunk hole. I know section 5 says 7 clicks past flush is the proper depth, however it didn’t seem like the dimple fit properly. Attached is a link to a picture with a AN426AD4 rivet inserted into the hole for reference. I’m worried I’ll need to order new reinforcement angles. What are your thoughts?
https://flic.kr/p/GUigan
I countersunk HS-710 and HS-714. I think I may have gone a little too deep in an attempt to make the dimples on HS-702 fit into the countersunk hole. I know section 5 says 7 clicks past flush is the proper depth, however it didn’t seem like the dimple fit properly. Attached is a link to a picture with a AN426AD4 rivet inserted into the hole for reference. I’m worried I’ll need to order new reinforcement angles. What are your thoughts?
https://flic.kr/p/GUigan
Last edited: