I bought an adjustable ram from ATS (the 214CAR) and it doesn't fit. It also doesn't look like the picture on their site; this one looks more like the AE274 listed except it has a different anti-rotation design.
The base of the ram is 0.630" wide but the opening in my riveter is 0.615" wide near the yoke holders and tapers down to about 0.525" wide. I can probably grind off the extra 0.020" or so in width and then round over the corners to make it fit but is this typical?
My squeezer is a genuine CP-214 but it's of unknown vintage.
The base of the ram is 0.630" wide but the opening in my riveter is 0.615" wide near the yoke holders and tapers down to about 0.525" wide. I can probably grind off the extra 0.020" or so in width and then round over the corners to make it fit but is this typical?
My squeezer is a genuine CP-214 but it's of unknown vintage.