First, I have already installed black Van's corrugated conduit in the wing. I have added the Duckworth landing lights out near the wing tips.
Is is possible to cut a hole in the conduit to run the landing light wire? I would imagine some sort of grommet is needed to prevent the conduit from chafing the wires, but I can't see how one would fit well or securely.
My other thought would be to just chop out a section of the conduit and install two grommets on the exposed ends and put the wire in there.
Is is possible to cut a hole in the conduit to run the landing light wire? I would imagine some sort of grommet is needed to prevent the conduit from chafing the wires, but I can't see how one would fit well or securely.
My other thought would be to just chop out a section of the conduit and install two grommets on the exposed ends and put the wire in there.
Last edited: