I discovered that the phone cable connector on WH-00059 does not fit through the F-01429 Left and Right bellcrank rib holes as called out on page 10-26. Even if I remove the snap bushings it still doesn't fit. What have others done here? I'm always reluctant to remove metal, and if I drill out the holes to make them larger I'll need to install a different size (larger) snap bushing.
Also, on page 10-29 I can't tell if the F-01475 top skin has an inside or outside. It is a symmetrical part. Any advice on which side goes out on this part?
Oh, and I discovered a mistake on page 10-19. Where step one is telling you to rivet the side skins to all those parts, F-01409 is incorrectly included here. Bulkhead F-01409 does not get installed until page 10-27.
Thanks,
Also, on page 10-29 I can't tell if the F-01475 top skin has an inside or outside. It is a symmetrical part. Any advice on which side goes out on this part?
Oh, and I discovered a mistake on page 10-19. Where step one is telling you to rivet the side skins to all those parts, F-01409 is incorrectly included here. Bulkhead F-01409 does not get installed until page 10-27.
Thanks,