I have a Stratus ESGi installation question. Seems I often run into issues outside of business hours.
Anyway, wrapping up the Stratus ESGi installation but not sure if the Dsub connector mounts to the back of the tray or to the inside of the tray. With the connector mounted to the outside/back of the tray, the connector does not seem to make a complete connection when I slide the transponder in and tighten it down with the allen wrench.
I don't see anything regarding this issue in the installation manual.
Earlier today, I spoke with Chris at Stein Avionics (where I purchased the unit plus the harness) and he thought the connector mounted to the inside of the tray (it's a Cannon Dsub connector).
I would be very grateful for the help should you remember how you installed the Dsub connector to the tray.
Last edited by freddie : 06-30-2017 at 09:28 PM.