Originally Posted by mturnerb
Sorry for the huge photo - the dies are angled to match the angle of the trim tab/elevator trailing edges. Sorry don't have photos of it being applied to the actual edges, but I think it's intuitive when you look at this photo. Tricky part is to hold one side against the manufactured head, flush, so that the shop head ends up flush on the angled opposite side.
Ah... Those were the magic words: "...the dies are angled." Now I get it. Thanks much! I already ordered the pinned dies!
Punta Gorda, FL
RV-14A (N914CH Reserved)
* (VS, Rudder, HS complete, elevators in progress)
* Donated for 2016, 2017