Originally Posted by caapt
I am bogged down trying to mount my VPX and a remote radio (garmin) in the area forward of the sub panel on the right side. I want to be able to remove them if necessary. Ideas and pics would be much appreciated.
Fabricated a shelf, on a hinge (removable pin), that swings down below the subpanel area. Have to allow 'service loop' slack in the wiring harnesses to be able to keep it all intact, or plan to disconnect connectors. I chose slack in the harnesses.
The top side of the shelf was a 'future' space, and there are some harnesses that pass over that area but nothing needed to be attached later.
A single AN3 bolt attaches to the bracket in foreground, the shelf is lightweight but rigid enough for one bolt.
RV-6A QB Tip-Up, 1st Flight 3/18/17
O-360-J2A (modified & F/I), Sensenich FP (cruise)
VP-X Sport, Dynon SkyView, VFR day
(FFZ) Mesa, AZ - N234GB -