Home > VansAirForceForums

- Donate yearly (please).
- Advertise in here!

- Today's Posts | Insert Pics

Go Back   VAF Forums > Model Specific > RV-7/7A
Register FAQ Members List Calendar Search Today's Posts Mark Forums Read

Thread Tools Search this Thread Display Modes
Old 02-04-2018, 05:55 PM
CharlesC CharlesC is offline
Join Date: Nov 2017
Location: El Paso, TX
Posts: 3

G'Day, Mick,
If you look closely at the drawing (Larco posted), the hole that the jackscrew is supposed to go through in the elevator spar is pre-punched and is in the lower half of the spar. It is possible to build the elevator skeleton using the spars with the hole in the upward half. I made this mistake and thankfully caught it before I riveted on the skins. I had to disassemble the skeletons and re-build them flipping the spars so they would be used in the opposite elevators. That caused the hole to be in the lower side, and the jackscrew goes right through the center. Best regards,
Reply With Quote

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

All times are GMT -6. The time now is 12:20 AM.

The VAFForums come to you courtesy Delta Romeo, LLC. By viewing and participating in them you agree to build your plane using standardized methods and practices and to fly it safely and in accordance with the laws governing the country you are located in.