Every flange! The straightening tool is a godsend. It was the first tool I made!
The picture above is about all you need to build your own. My block, opposite the working end of the arm, was cut back 10 degrees to allow for springback. The resulting flanges came out at a nice 90-deg angle.
N430WB (reserved) RV-7 #74152, tip-up. Avionics and FF underway!
Log at: http://rv7.wbencze.com Defeating gravity one rivet at a time
VAF 2018 donation happily made
Thx for the help. I have the tool and set it up as per another blog on here...11 degrees. I like the square idea and will start using that to check if im off or not. I would rather spend a lot of time getting this part right.