NovaBandit
Well Known Member
I'm going to be running dual Lightspeed ignition boxes on my RV10. On my first go at routing the plug wires, I had it looking very neat and tidy, planning to have the plug wire bundles wire tied together. But then I remembered that I should be keeping some separation between the plug wires to help prevent cross-firing between the wires. So now I need to figure out how to secure the plug wires in a neat fashion, while still maintaining some plug wire separation.
I'm mounting all 6 coils on a plate directly behind the rear baffle.
Does anyone have any pictures of a good way to do this?
As a side note, this is the general layout of the coils and plug wires if anyone has any comments:
I'm mounting all 6 coils on a plate directly behind the rear baffle.
Does anyone have any pictures of a good way to do this?
As a side note, this is the general layout of the coils and plug wires if anyone has any comments: