HS-0001 Which Way Is Up?

Cross posting, doesn't look like the SB thread is very active.

On DWG 3r4 and the SB drawing, they show conflicting info.

SB shows the 3/8" side to be down and the plans show the 3/8" side to be up. I of course already separated the pieces. Based on the way the edges are drawn in the SB and the 3/8" side, those look more accurate.

But wanted to double check...

Thanks.

According to Sterling @ Van's, he said the little notched section of the doubler, as shown towards the middle of the attached pieces shown in SB is correct and ultimately the measurement of the 3/8 vs 1/2 doesn't really matter. He acknowledged a discrepancy between the SB drawing and the plans.

Gotchas

amaris said:

According to Sterling @ Van's, he said the little notched section of the doubler, as shown towards the middle of the attached pieces shown in SB is correct and ultimately the measurement of the 3/8 vs 1/2 doesn't really matter. He acknowledged a discrepancy between the SB drawing and the plans.

Click to expand...

Did he mention any issue with installing it upside down?
Please post the issue and solution to the "Gotchas" thread so future builders may benefit.