QB Fuse Primed?
Quick question, just about to start riveting the tail cone to the QB fuse. . .
It is my understanding that the fuse interior had a wash primer sprayed on it prior to departing the PI.
Looks like it to me. However, a local A&P dropped by the hangar yesterday and said, "that doesn't look like any wash primer I have seen."
Before we start riveting next week, just want to make sure I am correct There was a light primer sprayed on the interior. All the bulkheads and tail cone skins are primed because I did them.
ATP - CFII/MEI
Tail Cone & Empennage Done'ish 11/18/17 Synergy Assisted
Fuselage - working on it. Wings - later
Finish - It's sitting here in a big box
Engine - Ordered from an undisclosed builder, ready summer 2019