VansAirForceForums  
Home > VansAirForceForums

- POSTING RULES
- Donate yearly (please).
- Advertise in here!

- Today's Posts | Insert Pics

  #1  
Old 09-24-2018, 03:39 PM
rotoiti's Avatar
rotoiti rotoiti is offline
 
Join Date: Jan 2013
Location: Bay Area, CA
Posts: 167
Default High oil consumption on an IO-540

My RV-10 has an old engine (about 5,000 hours on it). It was top overhauled before installing in the -10, and it had installed all new, nickel cylinders at that time.

The oil consumption was always high but during 4 years (and 300 hours) I owned the airplane, the consumption increased from 1 quart per 3.5 hours to 2 quarts per 3 hours. Oil analysis shows increased nickel but that is in line with nickel cylinders.

This is still in-spec by Lycoming standards (current consumption 0.66 qt/h vs. 0.87 qt/h maximum) and my mechanic recommends just adding oil. Looking for a second (or third or...) opinion

Thanks!
__________________
Llama (RV-10), flying. Currently down for engine overhaul.
Reply With Quote
  #2  
Old 09-24-2018, 03:56 PM
William William is offline
 
Join Date: Nov 2006
Location: Wimauma Airpark, Florida (FD77)
Posts: 407
Default

Thatís a very high oil consumption rate. How many hours are on the cylinders?
__________________
RV6A flying as of November 8, 2016. N717WK
Reply With Quote
  #3  
Old 09-24-2018, 04:06 PM
RONSIM's Avatar
RONSIM RONSIM is offline
 
Join Date: Feb 2008
Location: Largo, FL
Posts: 845
Default High Oil Consumption, Until:

Our -10, ECI (new) Nickel cylinders had high oil consumption (qt every 4 hrs). We "broke in" with mineral oil and switched to Aeroshell after 50 hrs -- oil consumption remained high ----- THEN, we found out that ECI recommended Phillips XC for break-in and permanent use. We switched to the Phillips, and, over time, the oil consumption stabilized at quart every 10-12 hrs. Just a data point, but worked for us.

I use the Phillips on my new (at the time) ECIs on the -6A and certainly have no complaints.

Ron
__________________
RV-10 Co-built, maintained, flown (sold)
RV-8A Maintained and flown (Sold)
RV-6A Bought and Flying (N177RV), upgrades $$$
IO360, 180HP/CS, AFS 5600T, D10A, G650, G430, G327, ADS-B, VIZ385 AP
Very Happy Contributor
Comm, SMEL, CFII, A&P
Based at KCLW (Clearwater, FL)
Reply With Quote
  #4  
Old 09-24-2018, 04:17 PM
rotoiti's Avatar
rotoiti rotoiti is offline
 
Join Date: Jan 2013
Location: Bay Area, CA
Posts: 167
Default

385 hours on the cylinders, since 2012 I believe.
__________________
Llama (RV-10), flying. Currently down for engine overhaul.
Reply With Quote
  #5  
Old 09-24-2018, 06:42 PM
grubbat's Avatar
grubbat grubbat is offline
 
Join Date: May 2012
Location: Ga
Posts: 577
Default Break-in

If the cylinders weren’t broken in properly, they may never break in no matter how much time they have on them. Assuming valves are good, pull them, crosshatch the cyl, install new rings, then break in properly.
Good luck !!
__________________
Craig

RV-3 Sold
RV-4 Sold
C-140 In a barn
Maule MXT-7 Sold
RV-6a Sold
Twin Comanche - Sold
RV-9 IO-360 CS, Built and Flying
J3-65 Cub - low and slow stuff
Comanche 260 - poor mans RV-10
Reply With Quote
  #6  
Old 09-24-2018, 09:23 PM
William William is offline
 
Join Date: Nov 2006
Location: Wimauma Airpark, Florida (FD77)
Posts: 407
Default

Quote:
Originally Posted by rotoiti View Post
385 hours on the cylinders, since 2012 I believe.
With that high of a oil burn with such low hours on your cylinders I would definitely be pulling the cylinders for inspection. What do your spark plugs look like? How about the inside of your exhaust pipes?

Bill
__________________
RV6A flying as of November 8, 2016. N717WK
Reply With Quote
  #7  
Old 09-25-2018, 01:55 PM
rotoiti's Avatar
rotoiti rotoiti is offline
 
Join Date: Jan 2013
Location: Bay Area, CA
Posts: 167
Default

Yes, I have no idea if the cylinders were broken in properly. I bought this airplane when it had 106 hours on it.

Spark plugs look fine, no fouling. I have dual LSE Plasma 3. My mechanic insists on aviation plugs, so that's what is installed there now. Not sure if that could be the reason.

Compression is fine, two cylinders are in 69-70 range, rest is 75-77.
__________________
Llama (RV-10), flying. Currently down for engine overhaul.
Reply With Quote
Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -6. The time now is 09:15 AM.


The VAFForums come to you courtesy Delta Romeo, LLC. By viewing and participating in them you agree to build your plane using standardized methods and practices and to fly it safely and in accordance with the laws governing the country you are located in.