Hi guys, I?m finishing up my fadec swap and I?m having some trouble wiring up the ignition/mags. So I wired it up and I found that the right mag(without impulse coupler) was not running. When I did a run up the rpm dropped 600rpm. So I thought the timing was off so I retimed it. And I started farting around with the ignition wires... bad idea.
So I think I might have the wiring messed up on the right mag. It says to jump the right mag (since I have a left mag with impulse) to the ground next to the right terminal. i currently have right mag ground attached to the ground next to the right terminal and then I jumped the p lead to that same ground terminal.
Honestly I?m lost. Any help would be greatly appreciated. I check the the wiring diagram but he jump is throwing me off.
Do I need to put the right mag ground to the main ground (in the middle) and then jump the p lead to the ground next to the ?R? terminal?
Thanks in advance
D
So I think I might have the wiring messed up on the right mag. It says to jump the right mag (since I have a left mag with impulse) to the ground next to the right terminal. i currently have right mag ground attached to the ground next to the right terminal and then I jumped the p lead to that same ground terminal.
Honestly I?m lost. Any help would be greatly appreciated. I check the the wiring diagram but he jump is throwing me off.
Do I need to put the right mag ground to the main ground (in the middle) and then jump the p lead to the ground next to the ?R? terminal?
Thanks in advance
D