i have a Dynon Skyview classic installed in my RV9A , first flight was in 2015, the total flight time of the machine and ll components is about 50 hours ,
after close to two years of it sitting in a hangar , waiting to finish the paint job ,
i finally started the engine and taxied around the airport yesterday for about 45 minutes , i did a condition inspection last week and everything checked out ok ,
now , when i started the engine yesterday , it took a couple of tries ( 6 or rvrn 7 times till it started ) i noticed the voltage going down to 11 volts , with an audible alarm ( Low Voltage )
i started taxiing then i noticed the sky view rebooting , it did it 4 time yesterday , in the first 30 minutes , then it was normal till shut down .
today , i went again to fix a loose comm wire , i decided to start and taxi again , same thing , the dynon was rebooting the while time , it would stay on for about 3 minutes then it abruptly shuts down and restarts , todays taxi was about 30 minutes total .
there was a box in the bottom that showed that some events have been recorded and need to be transferred to a USB and sent to dynon, i didn't have a USB with me today but i will certainly do it tomorrow .
Any ideas on what would be the reason for this ? or has anyone experienced something similar with their sky view ?
by the way i have a single Unit only .
thanks for your replies
after close to two years of it sitting in a hangar , waiting to finish the paint job ,
i finally started the engine and taxied around the airport yesterday for about 45 minutes , i did a condition inspection last week and everything checked out ok ,
now , when i started the engine yesterday , it took a couple of tries ( 6 or rvrn 7 times till it started ) i noticed the voltage going down to 11 volts , with an audible alarm ( Low Voltage )
i started taxiing then i noticed the sky view rebooting , it did it 4 time yesterday , in the first 30 minutes , then it was normal till shut down .
today , i went again to fix a loose comm wire , i decided to start and taxi again , same thing , the dynon was rebooting the while time , it would stay on for about 3 minutes then it abruptly shuts down and restarts , todays taxi was about 30 minutes total .
there was a box in the bottom that showed that some events have been recorded and need to be transferred to a USB and sent to dynon, i didn't have a USB with me today but i will certainly do it tomorrow .
Any ideas on what would be the reason for this ? or has anyone experienced something similar with their sky view ?
by the way i have a single Unit only .
thanks for your replies