yankee-flyer
Well Known Member
Had an incident yesterday where the prop tips touched the runway. Did NOT break props, did NOT stop engine. One tip has maybe 1/16" abraded off, the other 1/16 to 1/8". One a standard category engine this would not be a problem but I've been told that Rotax requires that the gearbox be torn down and inspected and that this requires the engine be pulled and sent to an authorized facility.
1) is this in fact the case?
2) Is there a facility closer to Ohio than Lockwood>
3) suggestions??
THANKS!!
Wayne 120241
1) is this in fact the case?
2) Is there a facility closer to Ohio than Lockwood>
3) suggestions??
THANKS!!
Wayne 120241