fieldbaren
I'm New Here
My RV6 has an Aviation Products tail spring which needs replacing.I would like to use a Vans tail spring along with the new JD Air tail wheel assembly. the problem is the tail spring Vans sent me is different. The Aviation Products spring that goes into the fuselage has a constant diameter of 7/8", 6" long
while Vans spring is about the same diameter, but instead the surface that goes into the fuselage is less than 2" long then it tapers down for some inexplicable reason where at approximately 6" it goes to back to 7/8" diameter then tapers
towards the end of the spring to accept the tail wheel assembly. Has anybody else tried this?
while Vans spring is about the same diameter, but instead the surface that goes into the fuselage is less than 2" long then it tapers down for some inexplicable reason where at approximately 6" it goes to back to 7/8" diameter then tapers
towards the end of the spring to accept the tail wheel assembly. Has anybody else tried this?