What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Rudder

Bruce is right. If you see page 7-12, step #2 it calls for you to put a slight bend in the leading edge of the left skin.
 
I had a few gaps in my rudder LE. I drilled out the rivets and did some re-forming to remove the springback which causes the gaps. In a few places I added a rivet between the existing ones and also put an aluminum washer on the inside of the rivets (similar to those used on the baffles) to cinch things up better
 
Back
Top