What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Dynon autopilot servo connection.

LUKLA

Active Member
Folks, I got the dynon auto pilot servos for my RV 12 . Here is where I get confused. Page 44A-03 fig-1 shows how to insert pins to molex connector.
question is fig-1 doesn't says which servo ROLL or PITCH ??
My understanding is both pitch and roll servo.
Am I understanding right..

Help me out folks.
thanks
 
Folks, I got the dynon auto pilot servos for my RV 12 . Here is where I get confused. Page 44A-03 fig-1 shows how to insert pins to molex connector.
question is fig-1 doesn't says which servo ROLL or PITCH ??
My understanding is both pitch and roll servo.
Am I understanding right..

Help me out folks.
thanks

Lukla - Yes you are correct ... figure 1 on page 44A-03 applies to both the roll and pitch servos. Reread step 3 ... "Insert the wires from each Dynon AP SV32 Autopilot Servo into an ES-00009 Molex receptical".

Happy Building,
 
Lukla - Yes you are correct ... figure 1 on page 44A-03 applies to both the roll and pitch servos. Reread step 3 ... "Insert the wires from each Dynon AP SV32 Autopilot Servo into an ES-00009 Molex receptical".

Happy Building,

Thanks a lot John. I watch your blog a lot and get lots of help from there too.

Thanks again
Lukla
 
Back
Top