The flap W-00026 alignment template section 34 pg 02 doesn't seem to be in the fuselage kit. Doesn't appear on the parts list either. With the prefix of W- does it come in the wing kit?
Could someone shed some light 💡 on this please.
Thanks.
__________________
Kit 140241
Tail Feathers done
Fuselage kit completed.
wings almost complete.
Flaps and ailerons done.
Canopy next. Phew!
W-00026 is in the wing kit. Used on page 23-10 to align the ailerons.
__________________
RV14A #140083
Wings, empennage, fuselage and finish slow builds completed. Avionics and engine installed.
Down to last 90%.
2017 Donation
Thanks Tom23 seems odd that it's not included in the fuselage kit also as it's used to drill the flap actuator and called for in the plans.
I've got my wing kit here ( not unpacked yet) so I'll rummage around and see if I can find it.
__________________
Kit 140241
Tail Feathers done
Fuselage kit completed.
wings almost complete.
Flaps and ailerons done.
Canopy next. Phew!
This indeed comes in the wing kit. It is used several times in the plans at various points in the build.
And is the reason a specific kit purchase order is listed on the order form...
It may not officially state that is the designed/intended construction order, but it is.
There are numerous construction manual build details that to work, require that a specific build order be followed.
__________________
Any opinions expressed in this message are my own and not necessarily those of my employer.
Scott McDaniels
Hubbard, Oregon
RV-6A (aka "JunkyardSpecial ")
And is the reason a specific kit purchase order is listed on the order form...
It may not officially state that is the designed/intended construction order, but it is.
There are numerous construction manual build details that to work, require that a specific build order be followed.
Scott, I’m building a 10 and am fiddling around with rigging the flaps and ailerons on the wings ahead of doing the tips.
Given the similarities between the -14 and -10 airfoil would it be appropriate to use the W-00026 to set neutral for a -10? Just curious. Looks a little more robust method.
Cheers
__________________
Richard
RV7 VH-XRC Sold :-(
RV10 in progress.
Sydney, AUS
Scott, I’m building a 10 and am fiddling around with rigging the flaps and ailerons on the wings ahead of doing the tips.
Given the similarities between the -14 and -10 airfoil would it be appropriate to use the W-00026 to set neutral for a -10? Just curious. Looks a little more robust method.
Cheers
Yes, the same gauge tool should work for the RV-10 as well.
__________________
Any opinions expressed in this message are my own and not necessarily those of my employer.
Scott McDaniels
Hubbard, Oregon
RV-6A (aka "JunkyardSpecial ")
Flap actuator alignment tool.
Linear Mode
