VansAirForceForums  
Home > VansAirForceForums

- POSTING RULES
- Donate yearly (please).
- Advertise in here!

- Today's Posts | Insert Pics

  #1  
Old 11-03-2017, 09:23 PM
JDA_BTR JDA_BTR is offline
 
Join Date: Dec 2013
Location: Baton Rouge, LA
Posts: 459
Default Using Map Box for Remote Items

I kept looking at that map box hole in the subpanel and finally decided to dig in. I put angles in either side. Plan is to have folded 0.04 sheet on either side mounted to the angle. This will screw to the chassis for the gtx45r on the sides. The fold on either side will make a mount point for the gtr20 to sit on top. I’m using a scrap of j-channel to brace one side higher. I’ll post pics as I go but here are a few as it gets built up.



__________________
<------------------------------------------------->
N1463 seems a good number....
<------------------------------------------------->

Last edited by JDA_BTR : 11-03-2017 at 09:27 PM.
Reply With Quote
  #2  
Old 11-04-2017, 02:35 PM
JDA_BTR JDA_BTR is offline
 
Join Date: Dec 2013
Location: Baton Rouge, LA
Posts: 459
Default

Now the holes are drilled for 32-10 hex cap screws and k1000-3 nutplates installed with small head ad3 rivets. I’m installing in a way that I never have to get behind this panel to remove any device.



__________________
<------------------------------------------------->
N1463 seems a good number....
<------------------------------------------------->

Last edited by JDA_BTR : 11-04-2017 at 02:38 PM.
Reply With Quote
  #3  
Old 11-10-2017, 05:00 PM
JDA_BTR JDA_BTR is offline
 
Join Date: Dec 2013
Location: Baton Rouge, LA
Posts: 459
Default

I got the sides built and bent using 0.04 sheet for good rigidity. Lined it all up and drilled for the gtr20 first. Then fit the side angles and riveted those with an426-ad4 flush on the inside to not interfere with the gtr45 tray. Then fit and drilled the tray.

Struggled a bit with how I was going to screw the back end of the tray and got the bright idea to dimple the sheet in toward the tray and use a 426 rivet from the inside set nearly double flush. Worked well. I can’t take this assembly apart without drilling out a pair of rivets but it is soundly secured and I can slide it all in and out the front. If I ever use a different transponder I’d probably have to have a different arrangement anyway. Forgive the long screws it’s what I had.

Now to find some shorter fasteners for the gtr20 attach and I’m good!!!!

Still have to fit the front strap brace. Pics when that is done.

__________________
<------------------------------------------------->
N1463 seems a good number....
<------------------------------------------------->

Last edited by JDA_BTR : 11-13-2017 at 08:51 PM.
Reply With Quote
Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -6. The time now is 04:16 AM.


The VAFForums come to you courtesy Delta Romeo, LLC. By viewing and participating in them you agree to build your plane using standardized methods and practices and to fly it safely and in accordance with the laws governing the country you are located in.