PAN-DENMARK
Member
Hi,
Is there any kind of way to bridge serial RS-232 communication between an EFIS device and a Transponder that is not on the EFIS list of "approved" devices.
Both my EFIS (AFS) and my Transponder (Dittel) is able to control/share status over RS-232, but they are not speaking same language (protocol).
Can it be done with a "bridge" device that can be put between the units and act as translator ?
Really lost here.
Per
RV-6A
Copenhagen, Denmark
Is there any kind of way to bridge serial RS-232 communication between an EFIS device and a Transponder that is not on the EFIS list of "approved" devices.
Both my EFIS (AFS) and my Transponder (Dittel) is able to control/share status over RS-232, but they are not speaking same language (protocol).
Can it be done with a "bridge" device that can be put between the units and act as translator ?
Really lost here.
Per
RV-6A
Copenhagen, Denmark