My 10's QB control surfaces have the wedge protruding about 1/16" from the skin edges and it is maintained quite uniform in appearance,. This 1/16" gives the effect of coming to thin point at the edge of the part, though it leaves a stair step on each side. I am wondering what the preferred edge style is to stay consistent with the design.
I have the option of doing my best to work the edge to the closest I can get to a point. Or I can file it until it is flat, which would net me about a 3/32"-1/8" thick edge.
Does any one have guidance on the preferred edge profile for aerodynamic performance on these style of control surfaces?
Larry
I have the option of doing my best to work the edge to the closest I can get to a point. Or I can file it until it is flat, which would net me about a 3/32"-1/8" thick edge.
Does any one have guidance on the preferred edge profile for aerodynamic performance on these style of control surfaces?
Larry