rcarsey
Well Known Member
I had drilled the set-screw hole in the Canopy Handle (C-656) on an angle.. and my drill bit blew out through the opposite side of the handle. I re-ordered the part, expecting the same part as I got last summer in my Finish kit. (top left in the photo)
However, I was surprised to receive a C-656 which was already CNC'd with the full radius on the front end, radiused edges, and a nice rounded edge on the rear surface.
While my workmanship on this part was...acceptable, I'll take a computer made part over mine any day. Probably saved 30 minutes of time and the end result is looks much better.
However, I was surprised to receive a C-656 which was already CNC'd with the full radius on the front end, radiused edges, and a nice rounded edge on the rear surface.
While my workmanship on this part was...acceptable, I'll take a computer made part over mine any day. Probably saved 30 minutes of time and the end result is looks much better.
