Bayou Bert
Well Known Member
I am at the stage of the build, electrical and avionics finished and
top skin installed, time to install center support bar.
I decided to change color to flat black on roll bar and center support.
I bought this project with the roll bar already installed, and when I pulled
it off and could barely get a box wrench on the roll bar rear bolts, I gave
it a brief thought (denial) on what it was going to take to get it back on.
Roll bar and support back from powder coaters and decided to see about
install.
Soooo, is there some "trick" to getting the two level shim, washer and
nut on the rear bolts without bending the day lights out of the lower
ledge on the longeron?
All suggestions appreciated.
top skin installed, time to install center support bar.
I decided to change color to flat black on roll bar and center support.
I bought this project with the roll bar already installed, and when I pulled
it off and could barely get a box wrench on the roll bar rear bolts, I gave
it a brief thought (denial) on what it was going to take to get it back on.
Roll bar and support back from powder coaters and decided to see about
install.
Soooo, is there some "trick" to getting the two level shim, washer and
nut on the rear bolts without bending the day lights out of the lower
ledge on the longeron?
All suggestions appreciated.