When wired as suggested by my p-mag manual, does the p-mag go into setup mode every time the battery bus is activated?
From page 14:
If so, I guess this is not an issue, although it seems a bit strange. If the p-leads are activated before the battery is turned on, would it avoid the p-mag going into the setup mode?
From page 14:
2. Setup Mode is entered by turning 12 volt buss power ON, WHILE the p-lead switch is OFF (grounded). ...
If so, I guess this is not an issue, although it seems a bit strange. If the p-leads are activated before the battery is turned on, would it avoid the p-mag going into the setup mode?