This is a copy of the e-mail I received from Van's yesterday. I take it from the wording that a couple steps are certainly required, they may have been ommissions.
The release of the RV-14 fuselage includes many small improvements and refinements to the construction of the wing and empennage kits. Most do not greatly impact the construction of the kits as a whole, but a few very important callouts were amended during the course of kit development.
It is critical that the builder perform the following actions to complete the build of the Aft Fuselage:
10-13 REV 1: Rivet the Battery Angle & Bellcrank Rib Assembly to the F-01407 Bulkhead using 6 AN470AD4-4 Rivets.
10-32 REV 1: Rivet the F-14131 Upper Aft Fuselage Rib to the Top Skin Assembly to the F- 01407 Bulkhead as shown in Figure 1.
Be advised that these Plans page updates have been posted to our website on 10-17- 14. Please visit
www.vansaircraft.com, click on Support, then Service Information and Revisions.
The most recent revisions to the RV-14 Plans Pages can always be found at
http://www.vansaircraft.com/public/service-rv14.htm
Van's Aircraft, Inc 14401 Keil Rd. NE Aurora, Oregon 97002 503-678-6545 Fax 503-678-6560
www.vansaircraft.com