VansAirForceForums  
Home > VansAirForceForums

- POSTING RULES
- Donate yearly (please).
- Advertise in here!

- Today's Posts | Insert Pics


Go Back   VAF Forums > Model Specific > RV-10
Register FAQ Members List Calendar Search Today's Posts Mark Forums Read

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 09-19-2017, 08:35 AM
PrescottB787 PrescottB787 is online now
 
Join Date: Dec 2016
Location: Houston Texas
Posts: 29
Default Question on fluting tabs on Bulkheads and frames?

Page 10-12 step 3 say to "Heavily flute the tabs of the bulkhead and frames which have two punch holes". Should I assume this is to make it more rounded for a bitter fit of the top skins?? If this is the case why didn't they have us flute the Bottom of F-1011 bulkhead? Or did anyone do that? I had a **** of a time getting it to fit properly.
Thanks again for all the help!
Reply With Quote
  #2  
Old 09-19-2017, 09:07 AM
flion's Avatar
flion flion is offline
 
Join Date: Dec 2007
Location: Flagstaff, AZ
Posts: 2,456
Default

There's no room to flute the tabs on the F-1011. Since they are tabs with single holes, it should have been fairly easy to adjust the tabs to fit. Fluting does not round the tabs. That's pretty much set by the form for the bulkhead. But because of springback, the tabs and flanges may not be at 90 degrees (or in this case, because of the conical section, a little less) to the bulkhead. Fluting along a flange shrinks the outer edge, pulling it in and making the angle more acute. This is most apparent on a long curved flange such as found on the nose section of the wing ribs.

What you could do for the single hole tabs, to help them conform to a curved skin better, is use seaming pliers lightly at the outer corners to help them match the curve at the base of the tab. However, I had not problem fitting my skins to the bulkheads, and riveting pulled the tabs tightly to the skin.
__________________
Patrick Kelley - Flagstaff, AZ
RV-6A N156PK - Flying too much to paint
RV-10 14MX(reserved) - Fuselage on gear
http://www.mykitlog.com/flion/
EAA Technical Counselor #5357
Reply With Quote
  #3  
Old 09-19-2017, 09:54 AM
SeanM SeanM is offline
 
Join Date: Feb 2017
Location: Utah
Posts: 15
Default

I just completed this step last night. The middle bulkhead on the rear top skin was hard as I couldn't reach my hand around the inside to help align the holes. It did take a fair bit of work and time but it all pulled together perfectly.
Reply With Quote
Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -6. The time now is 06:23 PM.


The VAFForums come to you courtesy Delta Romeo, LLC. By viewing and participating in them you agree to build your plane using standardized methods and practices and to fly it safely and in accordance with the laws governing the country you are located in.