I'm having some fit issues in the tail and I know some other folks have had some similar issues.
The problem I'm having is with the spring itself. The weld at the front doesn't appear to be at the correct angle. When I try to install the aft-most bulkhead (F712 I think) it obviously requires the tails spring to be half-way in the mouse hole for the bulkhead to be installed. When the tail spring is in this position, there's a gap (probably 3/16" at least) at the top of the forward flange of the tail spring where it attaches to F711.
Anyone seen this and do I just add some shims?
I'm also having a heck of a time getting all the holes to line up but I think I just need to remove more material and make the hole bigger for the spring to pass through.
The problem I'm having is with the spring itself. The weld at the front doesn't appear to be at the correct angle. When I try to install the aft-most bulkhead (F712 I think) it obviously requires the tails spring to be half-way in the mouse hole for the bulkhead to be installed. When the tail spring is in this position, there's a gap (probably 3/16" at least) at the top of the forward flange of the tail spring where it attaches to F711.
Anyone seen this and do I just add some shims?
I'm also having a heck of a time getting all the holes to line up but I think I just need to remove more material and make the hole bigger for the spring to pass through.