Scott Hersha
Well Known Member
OK, I’m trying the google photo sharing instruction on this site to see if I can get it to work. I have the app on my iPad because my son in law, who is an excellent photographer, uses google to post pics of my grandchildren in a shared album. The instructions say something about right clicking on the photo, which of course you can’t do on an iPad, so I’m experimenting. My link looks too short to be right, but I won’t know until I try to post it.
This is a pic of my modified bent (welded) front stick on my new RV8 that I’m building.
https://photos.app.goo.gl/cA0KnZCs7M4PgTrD2
Wow!! It looks like it works! The stick is offset 2 inches and the offset clears the front edge of the seat pan. Some of the top of the stick will be removed when I install my infinity grip, but there’s still plenty of room for it to clear the bottom of the IP and in the full forward position it doesn’t reach the gear tower cross brace. Cut angle is 65 degrees - 2 cuts 2.3 inches apart. That cut off piece makes the offset piece - rotated making the upper and lower parts parallel.
This is a pic of my modified bent (welded) front stick on my new RV8 that I’m building.
https://photos.app.goo.gl/cA0KnZCs7M4PgTrD2
Wow!! It looks like it works! The stick is offset 2 inches and the offset clears the front edge of the seat pan. Some of the top of the stick will be removed when I install my infinity grip, but there’s still plenty of room for it to clear the bottom of the IP and in the full forward position it doesn’t reach the gear tower cross brace. Cut angle is 65 degrees - 2 cuts 2.3 inches apart. That cut off piece makes the offset piece - rotated making the upper and lower parts parallel.
Last edited: