Dynon 1000 and getting trim adjustment to work
2015 build RV-12 with a Dynon 1000 Touch.... we can see the trim gauge DISPLAY showing in the center instrument panel with all the red yellow and green gauges, in the lower right quadrant, but no indication where it really is, or when it is configured "clean" for takeoff.
However, something was missed in set up of the D1000 that shows on the scale of the gauge where the actual elevator trim tab is, in relationship to maximum up and maximum down on the trim tab, and where ZERO or no trim tab is, when the stick is in the middle and neutral.
Suggestions on Menu, where to go and look, and procedure to set it up correctly, proper range and verify on the gauge on the EFIS? A couple of older guys not the most menu or computer savvy. No 2 axis autopilot feature, yet, perhaps later on this year, order the servos.
Dynon 1000 Touch was ordered straight from Van's RV.
Last edited by NinerBikes : 01-22-2019 at 10:59 PM.