Van's Air Force
Don't miss anything! Register now for full access to the definitive RV support community.
PMA8000B Pins part number
- Thread starter vluvelin
- Start date
rleffler
Well Known Member
The easiest way to get the pins is to go to steinair.com. Although, I don't recall that the PSE 8000 used high density pins. In either case Steinair carries both sizes.
Canadian_JOY
Well Known Member
Julian - Don't know the MIL-SPEC part number but can direct you to a couple of sources of supply.
B&C is one vendor:
http://www.bandc.biz/d-subpinhighdensity.aspx
Steinair is another:
http://steinair.com/store.cfm?tlcatid=8
Stein also sells this crimper which does standard-density D-Sub pins:
http://steinair.com/storedetail.cfm?productid=291
But if you install this insert, it will do the high-density pins:
http://steinair.com/storedetail.cfm?productid=538
Also, don't forget the insertion/extraction tool:
http://steinair.com/storedetail.cfm?productid=289
Hope this helps.
B&C is one vendor:
http://www.bandc.biz/d-subpinhighdensity.aspx
Steinair is another:
http://steinair.com/store.cfm?tlcatid=8
Stein also sells this crimper which does standard-density D-Sub pins:
http://steinair.com/storedetail.cfm?productid=291
But if you install this insert, it will do the high-density pins:
http://steinair.com/storedetail.cfm?productid=538
Also, don't forget the insertion/extraction tool:
http://steinair.com/storedetail.cfm?productid=289
Hope this helps.
Raymo
Well Known Member
The standard pins for a DB-9/15/25 are...
Male pin:
https://www.aircraftspruce.com/catalog/elpages/malepin11-00139.php
Female pin:
https://www.aircraftspruce.com/catalog/elpages/femdpincrimp.php
High density pins for some Garmin type connectors are smaller but I suspect the above are what you need.
Male pin:
https://www.aircraftspruce.com/catalog/elpages/malepin11-00139.php
Female pin:
https://www.aircraftspruce.com/catalog/elpages/femdpincrimp.php
High density pins for some Garmin type connectors are smaller but I suspect the above are what you need.
Canadian_JOY
Well Known Member
The PMA8000 uses Hi Density d-sub PINS on the tray-side connectors (the unit itself has SOCKETS), or at least mine does!
