I expect that I will need to run some wires up to my glare shield - perhaps a HUD one day or at least an AOA - and I know some put their GPS puck there.
Does anyone have a clever way to do this? I've seen a simple plastic or rubber grommet but was thinking about something like some overlapping rubber flaps, or some brushes, or something else. It would allow a tight seal so stuff does not drop down there, and be big enough to pass the cable connector through, and allow for future expansion.
Thanks for any suggestions.
Does anyone have a clever way to do this? I've seen a simple plastic or rubber grommet but was thinking about something like some overlapping rubber flaps, or some brushes, or something else. It would allow a tight seal so stuff does not drop down there, and be big enough to pass the cable connector through, and allow for future expansion.
Thanks for any suggestions.
